A8L Quattro Sedan W12-6.0L (BSB) (2005)
-
Remove nut - 2 - and detach crank from wiper motor.
-
Detach wiper motor from wiper frame - arrows - .
Installing
Install in reverse order of removal, observing the following:
-
Screw wiper motor without crank to wiper frame - arrows - .
-
Plug in connector.
-
Switch on ignition.
-
Actuate flick wipe function and allow wiper motor to move to end position.
NOTE:
-
Every second time wiper motor is switched off it moves to an understroke end position which turns lip of wiper blade in opposite direction.
-
To do so, wiper motor moves down beyond its end position and then back up slightly. This understroke end position is not to be used to align
wiper crank.
-
Use must be made of end setting at which wiper motor moves directly and with no understroke to its end position. Actuate flick wipe function
again if necessary.
-
Switch off ignition and remove ignition key.