Allroad Quattro V6-2.7L Turbo (BEL) (2003)
-
Use only appropriate solvent to clean surfaces of piston and protective seal, then dry.
-
Apply thin coat of brake cylinder paste G 052 150 A2 to piston and protective seal before installing.
Fig. 3 Pulling dust seal on with outer sealing lip on piston
Fig. 4 Inserting inner sealing lip of dust seal using 3409 wedge
Note: Hold piston in front of caliper housing for this procedure.
Fig. 5 Screwing piston into brake caliper housing until stop
-
Install piston by turning threaded spindle -A- clockwise and knurled section -B- counter-clockwise.
Note: Outer sealing lip of dust seal will then engage in piston groove.