Allroad Quattro V6-2.7L Turbo (BEL) (2003)
Display Group 062
-
Observe display fields 3 and 4
-
Slowly depress accelerator pedal to full throttle position.
The percentage value in display field 3 should rise steadily, but without covering the full tolerance range between 3 - 93 %.
The percentage value in display field 4 should also rise steadily but without covering full range of values (in this case 4 - 49 %).
NOTE: The value shown in display field 3 should always be about the double of the value shown in display field 4.
If the display values do not appear as described:
-
Check voltage supply and wiring to accelerator position sensors
Checking voltage supply of accelerator position sensors
-
Remove storage compartment on driver's side.
-
Disconnect harness connector for accelerator position sensor.
-
Switch ignition on.
-
Connect hand-held multimeter (voltage range) between the following sockets on the connector:
6-pin connector on
Specification
wiring harness, socket