Cabriolet V6-2.8L (AFC) (1995)
Front Door Window Regulator: Service and Repair
Window Regulator, Disassembling and Assembling
Before removing, first determine whether the malfunction affects the cables, mechanical components or motor/drive gear.
This procedure is for replacing the motor/drive gear. It also applies for other mechanical components, except that the door glass upper end stop must also
be checked and/or adjusted.
-
Remove window regulator and door component carrier from door, then remove window regulator from door component carrier.
-
Hold housing cover and plastic bearing cover together by installing tie-wraps at cable outlets (arrows).
CAUTION!
DO NOT remove the two tie-wraps at any time before repair work is completed or repair will not be possible.
-
Remove drive cable housing cover screws (arrows).
-
Using a rocking motion, carefully remove drive cable housing and cable spool from motor in direction of arrows.
- Be careful not to damage mating surfaces.
- Be careful not to lose the 3 damping elements, which may fall Out at this time.
-
Remove plastic dust cover from new motor in direction of arrow.