Cabriolet V6-2.8L (AFC) (1995)
Rear Door Window Motor: Service and Repair
Removing
-
Remove rear side trim panel.
-
Disconnect electrical connector.
-
Remove door component carrier.
-
Mark position of window regulator motor in slots at mounting points.
-
Remove mounting nuts (arrows).
-
Remove window regulator motor from mounting studs and turn motor over.
-
Remove Torx(R) screws (arrows) from housing cover.
-
Remove housing cover carefully.
NOTE: Make sure cable does not jump off cable pulley (arrow).
-
Remove cable pulley (arrow) from window regulator motor with care.
-
Insert tie-wrap through center of cable pulley to secure cable on pulley.