Cabriolet V6-2.8L (AFC) (1995)
Grease before installing protective cap
10
Protective Cap
Attach to brake pad carrier and guide pin
Fig. 1 Removing piston from brake caliper
Fig. 1 Removing Piston From Brake Caliper
Remove piston by turning threaded spindle counterclockwise and knurled wheel clockwise.
Pull out sealing lip with piston.
NOTE:
If pistons are difficult to move, use a 13 mm wrench on the flats provided (arrow -A-).
Fig. 2 Install Protective Cap With Outer Sealing Lip On Piston
Fig. 3 Removing Sealing Ring
Use screwdriver to remove sealing ring.
NOTE:
When removing, make sure that the cylinder bore surface is not damaged.