Cabriolet V6-2.8L (AFC) (1995)
Blower Motor: Service and Repair
Fig. A
-
Remove glove box.
-
Mark wires and disconnect from fresh air blower
-
Remove four screws -A-. (Fig. A)
-
Loosen blower motor (and mounting plate) from heater box.
-
Disengage three rubber bushings -B-. (Fig. A)
-
Remove mounting plate and blower motor from heater box.
Fig. B
-
Remove connector assembly -A- (Fig. B) by turning mounting plate in direction of arrow.
-
Remove blower motor.
Install in reverse order of removal noting the following:
-
Spray three rubber bushings -B- (Fig. A) with silicone before installing.
-
Coat sealing surface of mounting plate with silicone rubber sealant before installing.
-
Place blower motor in heater box, then install mounting plate over blower motor
-
Rubber bushings -B- (Fig. A) must lock into mounting plate
NOTE: If necessary, reach through fresh air intake duct to hold blower motor from moving.