Cabriolet V6-2.8L (AFC) (1995)
^
Use T30 torx wrench and remove torx screws (1) located at the rear of the steering wheel
^
Remove air bag unit from the steering wheel by tilting it down; disconnect the electrical connection and store air bag properly
WARNING:
Always set a removed air bag unit down (e.g., on a workbench) with the horn pad facing upward.
^
Check for ground connection:
a) If a TORX SCREW is in position (A) on horn-plate circuit board, no further action is necessary
^
Reinstall parts, torque torx screws to 10 +/- 2 Nm (7 ft-lbs) and PROCEED TO SECTION C
b) If position (A) contains a RIVET, proceed to install a ground wire as outlined in Section B
B.
Install Ground Wire
^
Use T25 torx wrench to remove screw (2), including rubber washer and grommet, and discard