Cabriolet V6-2.8L (AFC) (1995)
Fuse Holder
-
Connect LED tester between GND and to terminal 1 of holder for injector valve circuit breaker -S72- (red holder).
-
Use On-Board Diagnostics (OBD) output diagnostic test mode to activate fuel pump relay.
^
Fuel pump relay must be activated
^
LED tester must light up
If LED tester does not light up:
-
Repeat test on circuit breaker holder terminal 2.
If LED tester does not light up:
Central Electric Panel With Detail Of Relay Position 6
-
Check wiring connection from circuit breaker to terminal 30 on relay location 6 for continuity per wiring diagram. Repair open circuit in
wiring if necessary.
Fuse Holder
-
Connect LED tester between GND and to terminal 1 of holder for HO2S circuit breaker -S73- (brown holder).
-
Use On-Board Diagnostics (OBD) output diagnostic test mode to activate fuel pump relay.
^
Fuel pump relay must be activated
^
LED tester must light up
If LED tester does not light up:
-
Repeat test on circuit breaker holder terminal 2.
If LED tester does not light up again:
-
Check wiring for continuity from circuit breaker holder and terminal 31 at relay position 6, according to wiring diagram.
-
Repair open circuit in wiring if necessary.
CHECKING BATTERY POSITIVE VOLTAGE (B+) FOR FUEL PUMP RELAY