Cabriolet V6-2.8L (AFC) (1995)
Air Bag: Service and Repair
Front Passenger Side Airbag Unit, Removing and Installing
Front Passenger Side Airbag Unit, Removing And Installing (Airbag III M.y. 1995)
1 - Airbag
- Install with front side up
2 - Torx(R) bolt
- Always replace
- Make sure that screw/nut threads are clean
- 24 Nm (17 ft lb)
3 - Connector
- Must never be disconnected
- If loose, replace airbag unit
- Identification: 2-pin, red
4 - Harness connector
- Identification: orange
- Must not be clamped between instrument panel and airbag, tape to airbag if necessary before installing
Removing
-
Disconnect single-pin airbag power supply harness connector.
-
Remove glove compartment.
-
Loosen Torx(R) bolt -2- and remove airbag -1- from instrument panel.
-
Disconnect harness connector -4- on tunnel and remove airbag -1-.
-
Install in reverse order of removal.
WARNING!
-
Connector -3- at the airbag unit must never be disconnected.
-
If connector -3- is loose, replace the airbag unit.
-
When an airbag unit has been removed, always set it down (e.g. on a workbench) with trim side facing upward.
NOTES:
-
Airbag mounting plate must be installed to ensure normal functioning of passenger side airbag.
-
When installing the airbag, always replace bolt -2- with a new one. Make sure that threads on screws and nuts are clean.
-
Make sure that cable to harness connector -4- is not clamped between the instrument panel and airbag. If necessary, tape the cable to the airbag
prior to installation.