Cabriolet V6-2.8L (AFC) (1995)
-
Remove both intake air silencer mounting bolts.
-
Disconnect intake air duct at mass air flow sensor.
-
Disconnect crankcase ventilation hose at large diameter end and disconnect from cylinder head covers.
-
Push intake air silencer to rear and lift upward.
-
Disconnect vacuum hose from throttle body, and remove intake air silencer.
-
Remove strainer from brake fluid reservoir, and remove brake fluid.
-
Disconnect both brake lines between brake master cylinder and ABS hydraulic unit.
-
Disconnect harness connector for brake fluid level sensor at brake fluid reservoir.
-
Remove brake master cylinder from brake booster.
-
Remove bolt for fastening crankcase breather from cylinder head cover.
-
Disconnect cruise control vacuum line.
-
Disconnect cruise control diaphragm with bracket from throttle body.
-
Disconnect connectors for knock sensor, heated oxygen sensor and oxygen sensor heater from bracket.
-
Plug holes for brake lines on brake master cylinder and ABS hydraulic unit with bleeder screws.
-
Disconnect check valve with vacuum line from brake booster.
-
Block off supply and return lines with hose clamps 3094.
-
Disconnect harness connector for engine coolant temperature sensor in rear coolant line.
-
Remove lower instrument panel knee bar on driver's side, refer to Body and Frame.
-
Remove safety clip from pin on brake pedal.
-
Remove bolt from clevis.
-
Disconnect spring from clevis.