Cabriolet V6-2.8L (AFC) (1995)
Steering Gear: Testing and Inspection
Voltage Supply For Module
NOTE: The Servotronic control module is installed under the rear seat on the right side.
-
Remove rear seat bench.
-
Disconnect harness connector from Servotronic control module.
-
Switch ignition on.
-
Set digital multimeter (Fluke 83 or equivalent) to measure voltage (20 volt range) and check for voltage at Servotronic control module harness
connector terminals 2 and 7, or terminals 3 and 7.
Specification: approx. 12 volts
-
If voltage is not as specified:
Check for open circuit in wiring, according to wiring diagram, and repair as necessary.