Cabriolet V6-2.8L (AFC) (1995)
all around the window opening so that it presses the fabric onto the poly-glass rear window.
-
Connect power supply cables from VAG 1742.
CAUTION! Make sure that the ends of the heating wire are not twisted together before being connected to the power supply. A short circuit could
occur causing burns to the convertible top fabric.
-
Switch on power supply to activate adhesive.
-
Switch off power supply after 2 1/2 to 3 minutes.
-
Let adhesive cool down for 20 minutes with VAG 1742 rear window installation tool in place on convertible top.
-
Remove rear window installation tool.
-
Cut ends of wires down to approx. 20 mm (3/4 in.) and insert securely between fabric and tape of zipper.
-
Test for water leaks.
Note: If water leaks occur around the rear window attach all components of VAG 1742 rear window installation tool again and connect the power
supply cables.
-
Apply extra pressure between outer and inner parts of rear window installation tool in area of water leak.
-
Disconnect power supply cables after 2-1/2 to 3 minutes.
-
Let adhesive cool down for 20 minutes with rear window installation tool VAG 1742 in place.
-
Remove rear window installation tool and retest for water leaks.