Cabriolet V6-2.8L (AFC) (1995)
Front Door Window Regulator: Service and Repair
Window Regulator, Removing and Installing
Removing
-
Remove door trim panel.
-
Remove regulator mounting bolts.
-
Disconnect combined window motor harness connector.
Separating connector (passenger side only)
-
Disconnect 2-pin connector from 3-pin connector by twisting 2-pin connector side-to-side, and pulling them apart (arrow).
NOTE: The connector for the left front window motor is not connected directly to the left front window switch, but to the 2-pin harness connector on
the window regulator wiring harness.
-
Remove door component carrier together with window regulator.
Installing
-
Position window glass half-open.
-
Install window regulator free of tension or stress.
-
Check for correct adjustment of upper end stop, and adjust if necessary using Torx(R) E-6 socket.
-
For passenger side only, connect 2-pin and 3-pin window regulator connectors by twisting 2-pin connector side-to-side and pushing together
(arrow).
-
Reconnect window motor harness connector.
-
Install remaining components in reverse order of removal.