Cabriolet V6-2.8L (AFC) (1995)
Windshield Washer Spray Nozzle: Service and Repair
Heated
Removing
-
Pull hose connector out backward, diagonally from spray jet (arrow).
-
Disconnect spray jet heating connector, located behind foam insulation in hood.
-
Using angled screwdriver, press retaining tab while pushing jet from hood.
Angled length of screwdriver = 20-30 mm (3/4-1-3/16 in.)
CAUTION!
Do not scratch paintwork with screwdriver.
Installing
Install in reverse order of removal, noting the following:
-
Push spray jet in from top until tab snaps into place.