Q5 Quattro V6-3.2L (CALB) (2009)
-
Remove the access/start authorization switch ( E415) - 1 - from the instrument panel and into the passenger compartment.
‹› If necessary, push the wiring harness on the central tube to the side.
-
Disconnect the electrical connector - 2 - by sliding the retainer - 3 - up - arrow - and pressing the release in.
Installing
‹› Tightening specification. Refer to => [ Access/Start Authorization Switch Tightening Specification ] See: Relays and Modules/Relays and
Modules - Steering and Suspension/Relays and Modules - Steering/Steering Column Control Module/Service and Repair/Steering Column Switch
Module and Electronic Ignition Lock Assembly Overview
Install in reverse order of removal, observing the following:
-
Install the center instrument vent.
-
On USA vehicles, install the right impact bar.
-
Install the driver side instrument panel cover.