Q5 Quattro V6-3.2L (CALB) (2009)
Parking Assist Control Module: Service and Repair
Parking Aid Control Module
Removing
-
If the control module was replaced, select the "Replace" function for the respective control module in "Guided Fault Finding" or " Guided
Functions".
-
Select the function or path:
-
Follow further instructions on display of (VAS 5051B).
-
Open the right luggage compartment side trim cover.
-
Disconnect electrical connectors - 2 through 4 -.
-
Remove the nuts - arrows -.
-
Remove the parking aid control module (J446) - 1 -.
Installing
‹› Tightening specification. Refer to => [ Parking Aid Assembly Overview ] See: Service and Repair/Parking Aid Assembly Overview.
Install in reverse order of removal, observing the following:
-
Follow the prompts on the (VAS 5051B) display with a new Parking Aid Control Module (J446).