Q5 Quattro V6-3.2L (CALB) (2009)
Rear Vision Camera: Service and Repair
Rearview Camera System Control Module
Rearview Camera System Control Module
The rear view camera system control module is located behind the luggage compartment left front side trim.
-
If control module is replaced, select "Replacement" function for appropriate control module in "Guided Fault-Finding" routine.
Use the Vehicle Diagnosis, Testing and Information System (VAS 5051A) to do so.
-
Turn off all electrical consumers.
-
Remove ignition key.
Removing
-
Open left luggage compartment storage bin.
-
Remove the bracket and radio and move it into the luggage compartment. Refer to => [ Radio, MMI ] See: Radio, Stereo, and Compact
Disc/Service and Repair/Radio.
The rear view camera system control module - 2 - is wedged into the bracket - 3 -.
-
Disconnect the connectors - 1 - and - 2 - on the rear view camera system control module - 3 -.
-
Push the tabs - arrows - outward and remove the rear view camera system control module - 2 - from the bracket - 3 -.
Installing
-
Install in reverse order.
-
Install the bracket with the radio. Refer to => [ Radio, MMI ] See: Radio, Stereo, and Compact Disc/Service and Repair/Radio.
-
Perform calibration. Refer to => [ Rearview Camera System, Calibrating ] See: Testing and Inspection.
Tightening specifications. Refer to=> [ Specifications ] See: Specifications.