Q5 Quattro V6-3.2L (CALB) (2009)
Auxiliary Input / Output Jack: Service and Repair
Chip Card Reader Control Module
Chip Card Reader Control Module
The chip card reader control module slides onto the glove compartment trim.
-
Turn off all electrical consumers.
-
Remove ignition key.
Removing
-
Open glove box.
-
Remove the chip card.
-
Slide the chip card reader control module - 1 - down in direction of arrow until it can be removed from the trim - 2 -.
-
Remove retaining clip - 4 -.
-
Disconnect the connector - 3 - on the chip card reader control module - 1 -.
Installing
-
Install in reverse order.
-
Make sure that all retaining tabs on the chip card reader control module engage in trim.