Q5 Quattro V6-3.2L (CALB) (2009)
Sunroof / Moonroof Module: Service and Repair
Power Sunroof Control Module
Power Sunroof Control Module
Removing
-
Remove the sunroof regulator.
-
Disconnect all connectors for the power sunroof control module.
-
Remove the screws on the sunroof motor and remove the power sunroof control module from the headliner.
Installation
-
Install the power sunroof control module - 2 - and tighten the screws - arrows - to 3.5 Nm.
-
Connect the connector - 1 - on the sunroof motor - 2 -.
-
Install the headliner..
-
After completing the work procedure, perform an adaptation on the sunroof motor. Refer to => [ Sunroof Adaptation ] See: Testing and Inspection
.