Q5 Quattro V6-3.2L (CALB) (2009)
/Page-3128002.png)
Installation
Installation is the reverse of removal.
‹› Replace the screws when installing or removing the glass panel.
-
Install the glass panel from the top into the roof.
-
Gently pull the inner seal - 3 - inward at the marked locations - arrow - and install the screws - 2 -, but do not tighten them.
-
Adjust the rear glass panel. Refer to => [ Front and Rear Glass Panel Height, Adjusting ] See: Adjustments
-
After the rear glass panel is adjusted, tighten the screws to 5 Nm.
-
After completing this procedure, perform an adaptation on the sunroof motor. Refer to => [ Sunroof Adaptation ] See: Testing and Inspection.
