Q5 Quattro V6-3.2L (CALB) (2009)
Wheel Speed Sensor: Service and Repair
Front ABS Wheel Speed Sensors
Front ABS Wheel Speed Sensors
‹› The sensor ring/rotor is installed in the respective wheel bearing unit and cannot be replaced.
Removing
-
Raise vehicle.
-
Unlock and disconnect connector - 1 - on speed sensor.
-
Remove bolt - 2 -.
-
Remove speed sensor from wheel bearing housing.
Installing
Installation is in reverse order of removal, with special attention to the following:
-
Before inserting speed sensor, clean hole inner surface and coat speed sensor all-round with Polycarbamide grease G 000 650.
-
Turn the steering completely left and right after installation, making sure the speed sensor wiring has sufficient clearance.
-
Lower vehicle.