Q5 Quattro V6-3.2L (CALB) (2009)
/Page-1448002.png)
‹› Removing and installing, refer to => [ Brake Caliper Piston ] See: Overhaul/Brake Caliper Piston
6 - Pressure nut
‹› To operate parking brake
7 - Pistons
‹› Removing and installing, refer to => [ Brake Caliper Piston ] See: Overhaul/Brake Caliper Piston
8 - Guide pins
‹› Grease before pulling on protective cap
‹› Delivered as a replacement part with sufficient grease.
‹› Replacing, refer to => [ Brake Guide Pins and Protective Caps, Replacing ] See: Overhaul/Brake Guide Pins and Protective Caps, Replacing
9 - Protective cap
‹› Pull onto brake carrier and guide pin.
‹› Replacing, refer to => [ Brake Guide Pins and Protective Caps, Replacing ] See: Overhaul/Brake Guide Pins and Protective Caps, Replacing
10 - Brake carrier with guide pins and protective cap
‹› Supplied as pre-assembled replacement part with sufficient grease on guide pins
‹› If protective caps or guide pins are damaged, install repair kit. Use grease packet supplied to lubricate guide pins.
11 - Protective cap
‹› Removing and Installing, refer to => [ Brake Caliper Piston ] See: Overhaul/Brake Caliper Piston
‹› Pull onto piston with the outer sealing lip.
