Q5 Quattro V6-3.2L (CALB) (2009)
‹› Use an extension to tighten the lower bolt - 16 -. An extension is not needed to tight the upper bolt - 17 -. Slightly move the wheel housing liner
away.
-
Install brake hose and electrical wire into the bracket on the stub axle carrier.
‹› Make sure the brake hose and wiring is correctly attached and secured inside the bracket on the stub axle carrier. This will prevent the hose and
wiring from coming out to the bracket.
-
Install wheels.
-
Lower vehicle.
Wheel bolt tightening specifications.
-
Switch on ignition.
Display on vehicle diagnostic, test and information system :