Q5 Quattro V6-3.2L (CALB) (2009)
/Page-1481002.png)
CAUTION!
Do not let any brake fluid run into the brake booster.
Installing
Installation is in reverse order of removal.
CAUTION!
Do not let any brake fluid run into the brake booster.
Use new nuts.
-
Replace sealing ring between brake master cylinder and brake booster.
-
When replacing brake master cylinder, ensure pressure rod in brake booster is seated correctly.
-
Press brake pedal down slightly. This makes it easier to guide the push rod into the brake master cylinder.
-
Install new nuts - 3 - and tighten. Note tightening specification.
-
Install brake lines - 2 - on brake master cylinder. Note tightening specification.
-
Install brake fluid reservoir - 1 -. Refer to => [ Brake Fluid Reservoir ] See: Brake Fluid Reservoir/Service and Repair/Brake Fluid Reservoir.
