Q5 Quattro V6-3.2L (CALB) (2009)
Balance Shaft: Service and Repair
Balance Shaft
Balance Shaft
Removing
‹› Transmission removed.
-
Remove belt pulley side sealing flange. Refer to => [ Sealing Flange with Crankshaft Seal, Belt Pulley Side ] See: Front Engine Plate/Service and
Repair.
-
Remove timing chain lower cover. Refer to => [ Lower Timing Chain Cover ] See: Timing Components/Timing Cover/Service and Repair/Lower
Timing Chain Cover.
-
Remove power take-off drive chain. Refer to => [ Power Take-Off Drive Chain ] See: Accessory Drive/Service and Repair/Power Take-Off Drive
Chain.
-
To protect against cuts, wrap the point and the cutting edges on an 8 mm diameter drill bit with insulating tape.
-
Secure balance weight - 2 - at rear of the engine with an 8 mm diameter drill bit - 1 -.
-
Remove bolt - 3 - and remove the balance weight from the balance shaft.
-
Remove bolt - 2 - while counterholding the balance weight using the drift and remove the balance weight - 1 - from balance shaft at the front of the
engine.
-
Remove bolts - arrows - and the balance shaft and bearing end bracket at the rear of the engine.