Q5 Quattro V6-3.2L (CALB) (2009)
/Page-653003.png)
‹› For cylinder block with oil groove
‹› Mark used bearing shells for reinstallation but not on the running surface
‹› Replace bearing shells that have worn down to the nickel layer
‹› Note installation position
‹› Insert new bearing shells for cylinder block with proper color marking => [ Allocation of crankshaft bearing shells for
cylinder block ]
15
Cylinder block
"TDC" marking locking bolt - tightening specification
‹› Replace O-ring.
-
Tighten locking bolt - arrow - to 14 Nm.
Oil pressure regulation valve (N428)
