Q5 Quattro V6-3.2L (CALB) (2009)
-
At the same time, rotate installation cartridge knurled screw right until points engage in valve keeper.
-
Move knurled wheel left and right slightly. This presses the valve keepers apart and captures them in the installation cartridge.
-
Release pressure fork.
-
Remove installation cartridge.
-
Unfasten guide plate and turn it aside.
-
Remove valve spring with valve spring plate.
-
Remove valve stem seal with the valve seal removal tool (3364).
-
Position valve lever on the puller and remove the valve stem seal - arrow -.
CAUTION!
Risk of damage when installing valve stem seals.
‹› Place plastic sleeve - A - that is attached to valve stem seals - B - on valve stem.
-
Lightly oil valve stem seal.
-
Slide valve shaft seal onto plastic sleeve.
-
Carefully press valve stem seal onto valve guide with Valve Stem Seal Drive (3365).
-
Remove plastic sleeve again.