Q5 Quattro V6-3.2L (CALB) (2009)
-
Disconnect electrical connector - 3 - for Engine Coolant Temperature (ECT) Sensor (G62).
-
Remove bolts - 1, 2, 4 and 5 -.
-
Open clamp, loosen hose clamp and remove front coolant pipe from coolant hoses - arrows -.
Installing
‹› Tightening specifications. Refer to => [ Coolant Pipes Assembly Overview ] See: Coolant Pipes Assembly Overview.
Installation is in reverse order of removal, note the following:
‹› Replace sealing rings.
‹› Secure all hose connections with hose clamps appropriate for the model.
-
Clean and smooth gasket sealing surfaces.
-
Coat gaskets with coolant and slide them onto the coolant pipe.
-
Connect coolant hose with the connector coupling => [ Connect coolant hose with the connector coupling ] See: Engine, Cooling and
Exhaust/Cooling System/Radiator/Service and Repair/Radiator and Coolant Fan Assembly Overview
-
Install left coolant pipes. Refer to => [ Left Coolant Pipes ] See: Left Coolant Pipes.
-
Install A/C compressor. Refer to => See: Heating and Air Conditioning/Compressor HVAC