Q5 Quattro V6-3.2L (CALB) (2009)
-
Remove the nuts - 1 - and remove the Tire Pressure Monitoring Control Module (J502) - 1 - upward.
Installing
Installation is in the reverse order of removal. Observe the following when doing so:
-
If the center console was pulled out of the instrument panel when pulling the carpet back, insert the center console with the pins - 1 - in the
instrument panel - 2 -.
-
Tighten nuts - 1 - to 2 Nm.
-
The system must be coded if the Tire Pressure Monitoring Control Module (J502) is replaced. Refer to => [ Tire Pressure Monitoring System
Usage ] See: Description and Operation/Tire Pressure Monitoring System Usage.