Q5 Quattro V6-3.2L (CALB) (2009)
Suspension/Suspension/Rear Knuckle/Service and Repair/Front Suspension
-
Slide wheel bearing housing onto the drive axle splines.
-
Insert both of upper control arm joint pins - 2 - in the wheel bearing housing and insert the bolt - 1 -.
-
Remove adhesive residue on the ball joint and guide link stub threads.
-
Install guide link on the wheel bearing housing and tighten.
-
Install control arm. Refer to => [ Track Control Arm ] See: Steering and Suspension/Suspension/Control Arm/Service and Repair/Front
Suspension/Track Control Arm.
‹› Push the upper control arms down as far as possible while tightening the bolts!
-
Tighten threaded connection - 1 -.