Q5 Quattro V6-3.2L (CALB) (2009)
-
Remove the bolts - arrows -.
-
Disconnect the electrical connector - 1 - for the brake fluid level warning switch (F34).
-
Disengage the wiring harness - 2 - on the engine compartment E-box.
-
Remove the engine compartment E-box - 3 -.
Installing
‹› Tightening specification. Refer to => [ Engine Compartment E-Box Tightening Specifications ] See: Fuse Block/Service and Repair/Engine
Compartment E-Box, Wire Junction, Fuse Holder and Battery Assembly Overview.
Install in reverse order of removal, observing the following:
-
Install the fuse panel B (SB) Refer to => [ Fuse Panel B in Engine Compartment E-Box ] See: Fuse Block/Service and Repair/Fuse Panel B in
Engine Compartment E-Box.
-
Install the alarm horn (H12) Refer to => [ Alarm Horn ] See: Accessories and Optional Equipment/Antitheft and Alarm Systems/Alarm
Horn/Service and Repair.
-
Connect battery. Refer to => [ Battery, Disconnecting and Connecting ] See: Starting and Charging/Battery/Service and Repair/Removal and
Replacement/Battery.
-
Install the windshield wiper motor. Refer to => [ Windshield Wiper Motor with Wiper Motor Control Module ] See: Wiper and Washer
Systems/Wiper Motor/Service and Repair/Windshield Wiper Motor with Wiper Motor Control Module.
-
Install the washer fluid reservoir filler neck. Refer to => [ Washer Fluid Reservoir Filler Neck ] See: Wiper and Washer Systems/Windshield
Washer Reservoir/Service and Repair/Washer Fluid Reservoir Filler Neck.