Q5 Quattro V6-3.2L (CALB) (2009)
Camshaft Position Sensor: Service and Repair
Camshaft Position Sensor
For the locations of the four camshaft position sensors. Refer to => [ Component Locations Overview ] See: Computers and Control
Systems/Locations.
Removing
-
Disconnect electrical connector on the respective camshaft position sensor.
-
Remove lower air filter housing section to remove the camshaft position (CMP) sensor 3 (G300) on cylinder bank 1. Removing lower section of
air filter housing. Refer to => [ Air Filter Housing, Lower Section ] See: Fuel Delivery and Air Induction/Air Cleaner Housing/Service and
Repair/Air Filter Housing, Lower Section
-
Remove coolant reservoir to remove the camshaft position (CMP) sensor 4 (G301) on cylinder bank 2.
-
Disconnect electrical connector to the engine coolant level warning switch (F66) on the bottom of the coolant reservoir and lay the reservoir aside
with the coolant hoses - 1 and 2 - and - 3 - attached.
Installing
-
Replace O-ring and lubricate it with clean engine oil.
-
Press camshaft position sensor in carefully by hand.
-
Tighten camshaft position sensor and connect electrical connector.
-
Further installation is in reverse order.
‹› Tightening Specifications. Refer to => [ Ignition Assembly Overview ] See: Service and Repair