Q5 Quattro V6-3.2L (CALB) (2009)
/Page-1765005.png)
-
Adjust the same front axle individual toe settings using fine adjustment screw - 5 -.
-
The difference between individual toe values must be less than 6' or they must be the same.
-
Bring bubbles - 2 - on measurement sensor - 1 - into balance.
-
Now using the laser beam - 3 - on the (VAS 6430), check if the laser beam contacts sensor lens.
‹› If the laser beam still meets the sensor lens at this step after adjusting the same individual toe values, the (VAS 6430) is aligned correctly
