Q5 Quattro V6-3.2L (CALB) (2009)
‹› Check fluid level, refer to => [ Power Steering, Checking Fluid Level ] See: Testing and Inspection/Power Steering, Checking Fluid Level
4
Bolt
‹› 9 Nm
5
Bolt
‹› 9 Nm
6
Spring clamp
‹› Removing and installing using the Hose Clip Pliers (V.A.G 1921)
7
Bolt
‹› 9 Nm
8
Bolt
‹› 9 Nm
9
Wiring bracket
‹› For securing the intake hose on the longitudinal member, refer to => [ Lines and Hoses Assembly Overview ] See: Power Steering
Line/Hose/Service and Repair/Lines and Hoses Assembly Overview.
10
Return line
‹› From the power steering gear to the reservoir
CAUTION!
‹› Insert the return line completely when installing.
‹› Mounting on the subframe, refer to => [ Lines and Hoses Assembly Overview ] See: Power Steering Line/Hose/Service and Repair/Lines and
Hoses Assembly Overview
‹› Note location on reservoir, refer to => [ Hoses to Reservoir, Hydraulic Oil Cooler and Return Line, Installation Locations ] See: Power
Steering Line/Hose/Service and Repair/Hoses to Reservoir, Hydraulic Oil Cooler and Return Line, Installation Locations
11
Seal
‹› Always replace after removal
12
Power Steering Gear
‹› Removing and installing, refer to => [ Power Steering Gear ] See: Steering Gear/Service and Repair/Removal and Replacement/Power
Steering Gear
13
Bolt
‹› 20 Nm
14
Pressurized line
‹› From the power steering pump to the power steering gear
CAUTION!
‹› Insert the pressure line completely when installing.
‹› Mounting on crossbrace, refer to => [ Lines and Hoses Assembly Overview ] See: Power Steering Line/Hose/Service and Repair/Lines and
Hoses Assembly Overview
‹› Wiring connection installation location, refer to => [ Lines and Hoses Assembly Overview ] See: Power Steering Line/Hose/Service and
Repair/Lines and Hoses Assembly Overview