audi Workshop Repair Guides

Audi Workshop Service and Repair Manuals

Steering Column Switch Module and Electronic Ignition Lock Assembly Overview|Page 7787 > < Steering Column Switch Module and Electronic Ignition Lock Assembly Overview|Page 7785
Page 1
background image

Steering Column Control Module: Service and Repair
Steering Column Electronic Systems Control Module

Steering Column Electronic Systems Control Module

The airbag spiral spring/return spring with slip ring (F138) and the steering angle sensor (G85 ) are integrated in the steering column electronic
systems control module (J527).

Special tools, testers and auxiliary items required

‹› Feeler gauge

Removing

-

If the control module was replaced, select the "Replace" function for the respective control module in "Guided Fault Finding" or " Guided
Functions"..

-

Select the function or path:

-

Follow further instructions on display of (VAS 5051B).

CAUTION!
Risk of damaging coil connector.

‹› Steering must be in center position (wheels in straight ahead position) when removing and installing coil connector with slip ring.

‹› Coil connector with slip ring is not to be turned following removal. 

-

Adjust steering wheel downward and to rear as far as possible, use entire adjustment range of steering column adjustment for this.

-

Remove the driver airbag. Refer to => Body Interior

 69 Removal and Installation.

-

Remove steering wheel. Refer to => Suspension, Wheels,

Steering 40 Removal and Installation.

-

Remove steering column trim. Refer to => Body Interior

 68 Removal and Installation.

-

Remove bolt - 1 -.

Steering Column Switch Module and Electronic Ignition Lock Assembly Overview|Page 7787 > < Steering Column Switch Module and Electronic Ignition Lock Assembly Overview|Page 7785