Q5 Quattro V6-3.2L (CALB) (2009)
1. Nut (T10254/4)
2. Press Piece (T40186/1)
3. Subframe
4. Tube (T40033/3)
5. Support Ring (T10205/4)
6. Hydraulic Cylinder (VAS 6178)
7. Nut (T10254/4)
8. Spindle (T10254/5). The spindle pins face downward.
CAUTION!
‹› Hold the Hydraulic Cylinder (VAS 6178) securing during the pressing procedure.
‹› The bonded rubber bushing releases abruptly. There is a risk of the injury from the tools and bonded rubber bushing falling down!
Installing
Installation is in reverse order of removal. Observe the following when doing so:
‹› Before installing the bonded rubber bushing, make sure the Spindle (T10254/5) is able to fit through the hole in the inner core of the bushing.
When drilling through the inner core of the bonded rubber bushing, it is possible the Spindle (T10254/5) may not be drilled all the way through, if
so, it must be drilled again.
CAUTION!
Wear protective eyewear while drilling.
-
Gently pre-load the bonded rubber bushing - 2 - with cover horizontally in the vice clamp as illustrated - 1 -. Be sure not to damage the outer layer
of the bonded rubber bushing.