Q5 Quattro V6-3.2L (CALB) (2009)
Installing
Installation is in reverse order of removal. Observe the following when doing so:
‹› The camera visual area on the inside of the window must not be covered with condensation or dirt. If it is, clean the visual window by hand using a
Cleaning Solution.
‹› Make sure the Lane Assist Control Module (J759) fits correctly in its bracket.
‹› If the Directional Stabilization Assistance Control Module (J759) is replaced, the Camera and the control module must be recalibrated. Refer to =>
[ Lane Assist Calibration Procedure ] See: Alignment/Service and Repair/Procedures/Lane Assist Calibration Procedure.