Q5 Quattro V6-3.2L (CALB) (2009)
‹› The open side of the seal faces the Thrust Piece ( T40164).
-
Install the shaft seal for the left flange shaft using the Thrust Piece (T40164) all the way; when doing this, do not bend it.
-
Fill area between sealing lip and dust lip halfway with Sealing Grease (G 052 128 A1).
-
Install the differential.
-
Install the front final drive cover with a new O-ring and tighten the bolts. Refer to => [ Tightening specification and sequence, front
final drive cover ] See: Front Final Drive Sealing Rings Assembly Overview
-
Install left flange shaft. Refer to => [ Left Flange Shaft ] See: Left Flange Shaft.
-
Install right flange shaft. Refer to => [ Right Flange Shaft ] See: Right Flange Shaft.
-
After installing the transmission. Refer to => [ Front Final Drive and Transfer Case, Filling with Transmission Oil after Repair ] See: Transfer
Case/Fluid - Transfer Case/Service and Repair/Final Drive, Differential (0B5A Transmission)/Front Final Drive and Transfer Case, Filling with
Transmission Oil after Repair.