Q5 Quattro V6-3.2L (CALB) (2009)
/Page-1258003.png)
‹› The shoulder on the Tube 60 mm Diameter (VW 415 A ) - arrow - faces toward the Thrust Disc (VW 412).
-
Then press the spacer sleeve => [ (Item 2) Spacer sleeve ] See: Transfer Case/Service and Repair/Final Drive, Differential (0B5A
Transmission)/Center Differential Housing Assembly Overview in using the Tube 60 mm Diameter (VW 415 A).
-
Lightly oil outer circumference of shaft seal and drive in as far as stop with Thrust Piece (T40165).
‹› Installation position: Open side of shaft seal faces transmission.
-
Fill area between sealing lip and dust lip halfway with Sealing Grease (G 052 128 A1).
-
Press in flange shaft.
-
Install the flange shaft into the center differential housing from underneath.
-
Position the housing and flange shaft on the Pressure Plate (VW 402) under the shop press.
