Q5 Quattro V6-3.2L (CALB) (2009)
-
Remove Shift Lock Solenoid (N110).
Installing
Install in reverse order, paying attention to the following:
‹› Tightening specification. Refer to => [ Selector Mechanism Assembly Overview ] See: Shifter A/T/Service and Repair/Removal and
Replacement/0B5A Transmission/Selector Mechanism Assembly Overview.
-
Rotate the ball head - 1 - into the correct installation position.
-
Guide the Shift Lock Solenoid (N110) diagonally from above into the shift mechanism and tilt the bottom opposite direction of - arrow -.
‹› The ball head - 1 - must engage completely in the operating lever on shift mechanism. Press it down using a small screwdriver if necessary.
-
Secure the Shift Lock Solenoid (N110) on the retaining hooks - A -.
-
Place the cover - A - over the Shift Lock Solenoid (N110) and carefully let it engage - 1 through 3 -.