Q5 Quattro V6-3.2L (CALB) (2009)
4
Clamp
‹› Assembly overview, refer to => [ Selector Lever Handle and Selector Lever Transmission Range Position Display Unit Assembly Overview ]
See: Selector Lever Handle and Selector Lever Transmission Range Position Display Unit Assembly Overview
5
Selector Lever Transmission Range (TR) Position Display (Y26)
‹› Assembly overview, refer to => [ Selector Lever Handle and Selector Lever Transmission Range Position Display Unit Assembly Overview ]
See: Selector Lever Handle and Selector Lever Transmission Range Position Display Unit Assembly Overview
6
Nut
‹› For securing the shift mechanism to the body
‹› Quantity: 4
‹› 10 Nm
7
Gasket
8
Selector Lever Sensor System Control Module ( J587) with Tiptronic Switch (F189)
‹› Refer to=> [ Selector Lever Sensor System Control Module ] See: Relays and Modules - A/T/Shift Interlock Control Module/Service and
Repair
9
Selector mechanism function unit
‹› Can only be replaced as complete unit
‹› Refer to=> [ Shift Mechanism Function Unit ] See: Shift Mechanism Function Unit
10
Shift lock solenoid (N110)
‹› Refer to => [ Shift Lock Solenoid ] See: Actuators and Solenoids - A/T/Shift Interlock Solenoid/Service and Repair/0B5A Transmission
11
Transmission Park Selector Switch (F305)
‹› Consists of two microswitches on the circuit board on the Shift Lock Solenoid (N110)
‹› Can only be replaced together with Shift Lock Solenoid (N110), refer to => [ Shift Lock Solenoid ] See: Actuators and Solenoids - A/T/Shift
Interlock Solenoid/Service and Repair/0B5A Transmission
12
Noise Insulation
‹› Not installed on all vehicles
13
Lock washers
‹› Replace
‹› Quantity: 4
‹› For mounting the noise insulation to the selector mechanism function unit
14
Retaining clip
‹› Secures selector lever cable on selector mechanism function unit
15
O-Ring
‹› Replace
16
Selector lever cable
‹› Do not bend or kink