Q5 Quattro V6-3.2L (CALB) (2009)
/Page-1285002.png)
‹› Loosen the clamping screw approximately one turn, do not remove it.
‹› Clamping screw is only accessible with the selector lever in the " D" position.
‹› Selector lever must remain in the "D" position while clamping screw is loose.
-
Carefully move selector lever lightly forward and back without shifting into another selector position, this releases the tension on the selector lever
cable.
-
Shift selector lever into the "Tiptronic gate".
-
Tighten the clamping screw in this position with the socket and key (T40031) without touching the selector lever.
-
Check shift mechanism. Refer to => [ Selector Mechanism, Checking ] See: Testing and Inspection/Scan Tool Testing and Procedures.
If shift mechanism does not function properly after adjusting selector lever cable:
-
Bring selector lever cable into basic setting. Refer to => [ Selector Lever Cable, Bringing into Basic Setting ] See: Shift Linkage/Shift
Cable/Service and Repair/Procedures/0B6A Transmission.
