Q5 Quattro V6-3.2L (CALB) (2009)
/Page-1333008.png)
-
Using a flashlight, check all the gear selectors through the opening between the mechatronic and the transmission housing.
‹› All 4 gear selector yokes must fit correctly in the shift fork eyes.
-
Tighten the mechatronic bolts. Refer to => [ Mechatronic, tightening specification and sequence ] See: DSG Mechatronic Assembly Overview
Install in reverse order, paying attention to the following:
CAUTION!
There is a risk of destroying the transmission control module (Mechatronic) with static discharge.
‹› Always discharge "static electricity". Do this by touching a grounded object, e.g. vehicle ground, the vehicle or the hoist.
‹› Do not touch contacts in transmission connector with hands.
-
Make sure the connector is correctly connected to the mechatronic.
-
Install the ATF filter. Refer to => [ ATF Filter ] See: Fluid Filter - A/T/Service and Repair/Removal and Replacement/0B5A Transmission/ATF
Filter.
-
Install the ATF oil pan => [ Automatic Transmission Fluid Oil Pan ] See: Fluid Pan/Service and Repair/0B5A Transmission.
-
Top off ATF => [ ATF, Checking Level and Correcting ] See: Fluid Filter - A/T/Service and Repair/Procedures.
