Q5 Quattro V6-3.2L (CALB) (2009)
/Page-1357001.png)
Constant Velocity Joint: Overhaul
Peened Triple Roller Joint AAR 2600 i or 3300 i
Special tools, testers and auxiliary items required
‹› Thrust Plate (VW 401)
‹› Thrust Plate (VW 402)
‹› Punch (VW 408 A)
‹› Punch (VW 411)
‹› Tube (VW 416 B)
‹› Thrust Pad (VW 447 H)
‹› Hose Clamp Pliers (V.A.G 1275)
‹› Torque Wrench (V.A.G 1331)
‹› Torque Wrench (V.A.G 1332)
‹› CV Joint Boot Clamp Tool (V.A.G 1682)
‹› Assembly Tool (T10065)
‹› Slide Hammer - Complete Set (VW 771)
‹› Assembly Device (T40018) for triple roller joint AAR 3300 i
‹› or Assembly Device (T40084) for triple roller joint AAR 2600 i
‹› CV Joint Boot Clamp Tool (3340)
Triple Roller Joint AAR 2600 i or 3300 i, Disassembling
-
Clamp axle shaft horizontally in vise.
‹› Use protective vise covers.
‹› Make sure that axle shaft is not damaged.
-
Mark location of joint to axle shaft
If they are not marked and are not re-installed in their previously installed positions, noises may occur later during driving operation.
-
Mark the position of the joint protective boot to the joint.
A water-proof felt pen is well-suited for marking.
