Q5 Quattro V6-3.2L (CALB) (2009)
-
Carefully position the joint on the profile shaft using the Sleeve Press Tool (VW 522) and install it all the way using a hammer.
1. Protective covers
2. Inner constant velocity joint
3. Support Sleeve (VW 522)
The chamfer on inner diameter of ball hub (splines) must face and the contact collar on the drive axle.
-
Install a new circlip.
-
Check circlip for correct seating.
-
Add half of the drive axle grease into the joint on the boot side before installing the joint protective boot.
-
Lubricate the cover contact surface.
Applies to the 100 mm diameter inner CV joint