Q7 Quattro V6-3.6L (BHK) (2007)
Collision Avoidance Module: Service and Repair
Rear View Camera System Control Module J772, Removing And Installing
The Rear View Camera System Control Module J772 is located behind right luggage compartment side trim.
-
If control module is replaced, select the function "Replace" of respective control module in "Guided Fault Finding".
Use Vehicle Diagnosis, Testing and Information System VAS5051/5052 to do so.
CAUTION:
-
Switch off all electrical consumers.
-
Switch off ignition and remove ignition key.
Removing
-
Remove right luggage compartment side trim.
-
Remove nuts - 1 - and - 5 - (4 Nm).
-
Disconnect harness connectors - 3 - and - 4 -.
-
Remove Rear View Camera System Control Module J772 - 2 -.
Removing retaining bracket
Two retaining brackets are bolted to the Rear View Camera System Control Module J772.
-
Unscrew bolts - 5 - (2 Nm) and remove retaining bracket - 1 -.
-
Unscrew bolts - 4 - (2 Nm) and remove retaining bracket - 3 -.
Installing
-
Install retaining brackets first.
-
Installation of the Rear View Camera System Control Module J772 is the reverse of removal.
-
Perform calibration.
Rear View Camera R189, removing and installing
CAUTION:
-
Switch off all electrical consumers.
-
Switch off ignition and remove ignition key.