Q7 Quattro V6-3.6L (BHK) (2007)
Rear Vision Camera: All Technical Service Bulletins
Rearview Camera - Screen Display Flickers/Goes Blank
91 08 107
2015138/4
November 11, 2008.
Supersedes Technical Service Bulletin Group 91 number 07-28 dated July 11, 2007 for reasons listed below.
Affected Vehicle
91 Rearview camera screen display flickers or goes blank
Condition
The MMI screen flickers or completely goes blank when the rearview camera is in operation.
Technical Background
Bad contact at the aerial cable connector of the Front Information Display Control Head Control Module J523.
Production Solution
Wiring harness was optimized.
Service
1. Check for a bad connection by wiggling the aerial connector of Front Information Display Control Head Control Module J523.
2. If a bad connection is verified, the aerial cable between the rearview camera system control module J722 and J523 must be replaced. The original
harness may remain in the vehicle.
3. Cut off the connectors on both ends. Tape the connectors back to the harness.
Warranty