Q7 Quattro V6-3.6L (BHK) (2007)
3
Right-side angle bracket for mounting measuring unit for distance measurement
4
Plastic foot
‹› Three on underside of calibration platform
‹› Adjustable for aligning horizontal position of calibration platform
5
Linear laser on calibration platform
‹› Switching on and off
6
Measuring unit for distance measurement
‹› Notes on operation
7
Spirit level on calibration platform
‹› For checking horizontal position of calibration platform
8
Left-side angle bracket for mounting measuring unit for distance measurement
9
Measuring field of calibration platform
‹› Distance to rear wheel axle 1.47 m - 1.90 m - dimension A -
Setting up measuring device
-
Check which hole circle the rims have.
-
Equip wheel pick-ups appropriately.
-
To do so, secure three wheel bolt adapters in the hole circle to each wheel pick-up.
-
Attach paddles to both wheel pick-ups and secure them with clamping screw.
-
Set the wheel pick-ups on to wheel mounting bolts at the rear wheels.
When doing this, the wheel pick-ups are positioned by the " O-rings" in the adapters and held in place.
‹› Attach wheel pick-ups onto wheels so that any installed "anti-theft " wheel mounting bolts are not connected to the wheel pick-ups.
-
Set the paddles via the clamping screw so that they are free to move just above the ground.
Make sure paddles move easily.