Q7 Quattro V6-3.6L (BHK) (2007)
/Page-7233002.png)
Installation is reverse of removal, but note the following:
-
Insert new door pocket in door trim.
-
Press locking washers - 1 - out of seat on plastic dome - 2 - marked with - arrows - onto door pocket.
-
Install one screw - 2 - with washer - 1 - each into both anchorage points at rear of door pocket.
‹› Tightening specifications, refer to => [ Interior Door Trim Component Overview ] See: Front Door Trim Overview.
